Jeep Liberty: How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: How To Use Remote Start

All of the following conditions must be met before the engine will remote start:
• Shift lever in PARK.
• Doors closed.
• Hood closed.
• Liftgate closed.
• Hazard switch off.
• Brake switch inactive (brake pedal not pressed).
• Ignition key removed from ignition switch.
• Battery at an acceptable charge level.
• RKE PANIC button not pressed.
• System not disabled from previous remote start event
• Vehicle theft alarm not active

WARNING!
• Do not start or run an engine in a closed garage or confined area. Exhaust gas contains Carbon Monoxide (CO) which is odorless and colorless. Carbon Monoxide is poisonous and can cause serious injury or death when inhaled.

• Keep Remote Keyless Entry (RKE) transmitters away from children. Operation of the Remote Start System, windows, door locks or other controls could cause serious injury or death.

Remote Starting System — If Equipped
This system uses the Remote Keyless Entry (RKE) transmitter to start the engine conveniently from outside the vehicle while still maintaining security. The system has a range of approximatel ...

Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood A ...

See also:

Double locking
Never double lock the vehicle with people, children, or pets inside. In the event of an emergency they would be unable to escape and the emergency services would be unable to release them quic ...

Removing and Replacing the Floor Mat
The driver side floor mat is held in place by two retainers. 1. Pull up on the rear of the floor mat to unlock each retainer and remove. 2. Reinstall by lining up the floor mat retainer openings o ...

Lubricants and fluids
Checking the washer fluid level The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if ...