Jeep Liberty: To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.
NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.
To Exit Remote Start Mode Without Driving The Vehicle
Press and release the REMOTE START button one time or
allow the engine to run for the entire 15-minute cycle.
NOTE: To avoid unintentional shut downs, the system
will disable the one-time press o ...
Door Locks
...
See also:
Arming the system
In passive mode, the system will
automatically activate the alarm but
WILL NOT automatically lock the
doors. In order to lock the doors
you must either lock them as indicated
in step 4 b ...
Activating RSE
The RSE system can be activated using controls
on the front or rear screens.
From the front seat, press MEDIA (see the following
illustration) and select RSE.
From the rear seat, press the scree ...
Remote keyless entry system and the driver's seat and door mirrors
Remote keyless entry system and the driver's seat and door mirrors
The remote control transmitter also controls
the position of the power driver's seat and door
mirrors in the following way:
1 ...