Jeep Liberty: Tire Psi
Press and release the MENU button until Tire PSI is displayed.
Tire pressure information is displayed as follows:
• If tire pressure is OK for all tires, TIRE and a vehicle graphic are displayed with tire pressure values in each corner or the graphic.
• If one or more tires have low pressure, LOW TIRE and a vehicle graphic are displayed with tire pressure values in each corner of the graphic. Tire pressure values that are too low will be flashing.
• If the Tire Pressure System requires service, Service TPM System is displayed. Tire PSI is an information only function and cannot be reset.
Distance To Empty (DTE)
Shows the estimated distance that can be traveled with
the fuel remaining in the tank. This estimated distance is
determined by a weighted average of the instantaneous
and average fuel economy, ...
Elapsed Time
Shows the total elapsed time of travel since the last reset.
Elapsed time will increment when the ignition switch is
in the RUN or START position.
Elapsed time is displayed as follows:
hours:min ...
See also:
Stop/start (manual transmission only)
The Stop/Start system has been designed to
improve fuel efficiency. The system is
automatically activated when the ignition is
switched on.
When the engine has been stopped by the
stop/start syst ...
Setting the exterior mirrors
This function is only available in vehicles for Canada.
If the battery has been disconnected or completely discharged, the exterior mirrors
must be reset. The exterior mirrors will otherwise not fo ...
Changing the oil and oil filter
Change the oil and oil filter according to
the maintenance schedule in the “Warranty
and Maintenance Booklet”.
The engine oil and oil filter must be
changed more frequently than listed in
...