Volvo XC60: Removing the headlight housing
1. Switch off the ignition by briefly pressing the START/STOP ENGINE button.
2. Remove the remote key from the ignition slot1.
3. (Upper illustration under "Headlight housing").
1 Withdraw the headlight housing's locking pins.
2 Pull the headlight housing straight out.
CAUTION When disconnecting the connector, pull on the connector itself and not on the wiring.
4. (Lower illustration under "Headlight housing").
1 Unplug the wiring connector by holding down the clip with your thumb.
2 Pull out the connector with the other hand.
5. Lift out the housing and place it on a soft surface to avoid scratching the lens.
6. Replace the defective bulb(s).
Headlight housing
The entire headlight housing must be lifted out when replacing all front bulbs. CAUTION Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the he ...Reinserting the headlight housing
When reinserting the housing, be sure that the long locking pin (to the left in the illustration) is securely in place in both of its retaining clamps. 1. Plug in the connector until it clicks ...See also:
Power Steering Fluid Check
Checking the power steering fluid level at a defined
service interval is not required. The fluid should only be
checked if a leak is suspected, abnormal noises are
apparent, and/or the system is ...
Add-on Electrical Equipment
The OnStar system is integrated into the electrical architecture of the vehicle.
Do not add any electrical equipment. See Add-On Electrical Equipment on page 9‑64.
Added electrical equipment ...
Taking out the spare tire (vehicles without the spare tire cover)
Using the wheel nut wrench,
loosen the hold-down nuts by
turning them counterclockwise
until they can be loosened by
hand. Follow the order shown in
the illustration.
2 Remove all the wheel nu ...