Volvo XC60: Reinserting the headlight housing
When reinserting the housing, be sure that the long locking pin (to the left in the illustration) is securely in place in both of its retaining clamps.
1. Plug in the connector until it clicks into place.
2. Reinstall the headlight housing and locking pins. Check that they are correctly inserted. The headlight housing must be properly inserted and secured in place before the lighting is switched on or the remote key is inserted into the ignition slot.
3. Check that the lights function properly.
The headlight wiring must be connected and the housing must be securely in place before the ignition is switched on.
Removing the headlight housing
1. Switch off the ignition by briefly pressing the START/STOP ENGINE button. 2. Remove the remote key from the ignition slot1. 3. (Upper illustration under "Headlight housing"). &nb ...Removing the cover to access the bulbs
NOTE Before starting to replace a bulb, see page 322. 1. Open the retaining clamps by pressing them to the sides. 2. Pull the cover straight out. Reinstall the cover in the reverse order. ...See also:
Phone book
The hands-free system uses two phone books
(one with the cell phone's list of contacts and
one with contacts saved directly in the infotainment
system), which are combined to form
one phone bo ...
Maintenance Schedule
The following table shows the times when you should perform regular maintenance
on your vehicle. This table shows in miles, kilometers and months when you should
perform inspections, adjustments, ...
Warranties for your Hyundai vehicle
Please consult your Owner's Handbook &
Warranty Information booklet for your
vehicle's specific warranty coverage. ...