Jeep Liberty: Before You Begin Programming HomeLink
Be sure that your vehicle is parked outside of the garage before you begin programming.
For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink system.
Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN position and press and hold the two outside HomeLink buttons (I and III) for up 20 seconds or until the red indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–3515 or, on the Internet at www.HomeLink.com for information or assistance.
Garage Door Opener — If Equipped
HomeLink replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting or home security systems. The HomeLink unit is powered by your ve ...Programming A Rolling Code
For programming garage door openers that were manufactured after 1995. These garage door openers can be identified by the “LEARN” or “TRAIN” button located where the hanging antenna is a ...See also:
Wiper and washer
In freezing weather, do not use the
windshield washer until the windshield
is sufficiently warmed by the
defroster.
Otherwise the washer fluid can
freeze on the windshield, blocking
y ...
Adjusting the Sound
Press the sound (
) button to
select an appropriate setting: bass,
treble, fader, balance, subwoofer (if
equipped), and SVC (speed-sensitive
volume compensation). Turn the
VOL/SELECT knob ...
Ambient lighting
The LED ambient lighting can be adjusted for
colour and intensity via the touch screen. The
exterior lamps must be turned on while
changes are being made via the touch screen.
See 104, TOUCH SCREE ...