Nissan Rogue: RearView monitor (if so equipped) - Center display, heater, air conditioner, audio, phone 
and voice recognition systems - Nissan Rogue Owner's ManualNissan Rogue: RearView monitor (if so equipped)

When the selector lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle.

The system is designed as an aid to the driver in detecting large stationary objects to help avoid damaging the vehicle. The system will not detect small objects below the bumper and may not detect objects close to the bumper or on the ground.

- The rear view camera is a convenience

- The rear view camera is a convenience but it is not a substitute for proper backing up. Always turn and check that it is safe to do so before backing up. Always back up slowly.

- Objects viewed in the RearView Monitor differ from actual distance because a wide-angle lens is used.

Objects in the RearView Monitor will appear visually opposite than when viewed in the rear view and outside mirrors.

- Make sure that the lift gate is securely closed when backing up.

- Underneath the bumper and the corner areas of the bumper cannot be viewed on the RearView Monitor because of its monitoring range limitation.

- Do not put anything on the rear view camera.

- When washing the vehicle with high-pressure water, be sure not to spray it around the camera. Otherwise, water may enter the camera unit causing water condensation on the lens, a malfunction, fire or an electric shock.

- Do not strike the camera. It is a precision instrument. Otherwise, it may malfunction or cause damage resulting in a fire or an electric shock.

Do not scratch the camera lens when

Do not scratch the camera lens when cleaning dirt or snow from the lens.

How to use the setup button
When the SETUP button is pushed, the Setup screen will appear on the display. You can select and/or adjust several functions, features and modes that are available for your vehicle. Audio s ...

How to read the displayed lines
Guiding lines which indicate the vehicle width and distances to objects with reference to the bumper line A are displayed on the monitor. Distance guide lines: Indicate distances from the vehi ...

See also:

Changing a wheel
1. Apply the parking brake and put the gear selector in P. 2. Take out the jack*, lug wrench*, the towing eyelet and the wheel cover removal tool* stowed under the floor of the trunk. 3. Remov ...

Pairing
A Bluetooth&-enabled cell phone must be paired to the Bluetooth system and then connected to the vehicle before it can be used. See your cell phone manufacturer's user guide for Bluetooth ...

Rear seats
Folding Before folding the rear seats: - Secure the seat belts on the seat belt hooks on the side wall. (See “Seat belt hooks” later in this section.) - Release the connector tongue of t ...