Nissan Rogue: Programming HomeLink® for Canadian customers
Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener components.
Programming HomeLink®
To program your HomeLink® Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage door opene ...Operating the HomeLink® Universal Transceiver
HomeLink Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink® Universal Transceiver button. T ...See also:
Shifting Procedures
NOTE: If any of the requirements to select a new
transfer case position have not been met, the transfer case
will not shift, the indicator light for the previous position
will remain on, and the ...
Checking the brake pedal reserve distance
1) More than 2.56 in (65 mm)
Depress the pedal with a force of approximately
66 lbf (294 N, 30 kgf) and measure
the distance between the upper surface of
the pedal pad and the floor.
When th ...
Problems with the side windows
Problem: a side window cannot be closed because it is blocked by objects, e.g.
leaves in the window guide.
Remove the objects.
Close the side window.
Problem: a side window cannot be closed ...