Nissan Rogue: Precautions on cruise control - Cruise control - Starting and driving - Nissan Rogue Owner's ManualNissan Rogue: Precautions on cruise control

- If the cruise control system malfunctions, it will cancel automatically. The SET indicator on the vehicle information display will then blink to warn the driver.

- If the engine coolant temperature becomes excessively high, the cruise control system will cancel automatically.

- If the SET indicator on the vehicle information display blinks, turn the cruise control main switch off and have the system checked by a NISSAN dealer.

- The SET indicator on the vehicle information display may blink when the cruise control main switch is turned ON while pushing the ACCEL/RES, COAST/SET or CANCEL switch. To properly set the cruise control system, perform the following procedures.

Do not use the cruise control when

Do not use the cruise control when driving under the following conditions:
- when it is not possible to keep the vehicle at a set speed
- in heavy traffic or in traffic that varies in speed
- on winding or hilly roads
- on slippery roads (rain, snow, ice, etc.)
- in very windy areas
Doing so could cause a loss of vehicle control and result in an accident.

    Cruise control operations
    1. ACCEL/RES switch 2. COAST/SET switch 3. CANCEL switch 4. MAIN (ON·OFF) switch The cruise control allows driving at a speed between 25 to 89 MPH (40 to 144 km/h) without keeping your f ...

    See also:

    Type D audio set (if equipped)
    Type D audio set (if equipped) The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. - Power and audio controls: refer to page - Radio operation: ...

    Important operation tips for the air conditioning
    ● Park the vehicle in the shade. Parking in the hot sun will make the vehicle inside extremely hot, and it will require more to cool the interior. If it is necessary to park in the sun, op ...

    Vehicle set-up
    1. Park the vehicle on a level surface and apply the parking brake. 2. Start the engine and let it idle until it reaches operating temperature. 3. Turn the engine off and wait more than 10 min ...