Subaru Forester: Position light - Replacing bulbs - Maintenance and service - Subaru Forester Owner's ManualSubaru Forester: Position light

1. Turn the bulb socket counterclockwise

1. Turn the bulb socket counterclockwise and pull out the socket.

2. Pull the bulb out of the socket.

3. Install a new bulb.

4. Install the bulb socket by turning it clockwise.

    High beam light bulbs
    Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). 2. Disconnect the electrical connector from the bulb. 3 ...

    Front turn signal light
    It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. ...

    See also:

    Speed-dependent steering force
    Steering force increases with the speed of the vehicle to give the driver enhanced sensitivity. At low speed the vehicle is easy to steer in order to facilitate parking, etc. Steering force can ...

    Installing the steel cargo grid
    For information about the necessary tools and procedures for installing/removing the steel cargo grid, please refer to the assembly instructions that were included when the grid was purchased. ...

    If your vehicle must be towed
    If your vehicle has to be towed, it should be done by your Hyundai dealer or a commercial tow truck service. This will help assure that your vehicle is not damaged in towing. Also, professionals ...