Mercedes-Benz GLK-Class: Mounting a new wheel
WARNING
Always replace wheel bolts that are damaged or rusted.
Never apply oil or grease to wheel bolts. Damaged wheel hub threads should be repaired immediately. Do not continue to drive under these circumstances! Contact an authorized Mercedes-Benz Center or call Roadside Assistance.
Incorrect wheel bolts or improperly tightened wheel bolts can cause the wheel to come off.
This could cause an accident. Make sure to use the correct wheel bolts.
WARNING
Only use genuine Mercedes-Benz wheel bolts. Other wheel bolts may come loose.
Do not tighten the wheel bolts when the vehicle is raised. Otherwise, the vehicle could fall off the jack.
- : Wheel bolts for all wheels supplied by the factory
- ; Wheel bolts for the collapsible spare wheel
Always use wheel bolts 2 to mount the collapsible spare wheel. Using other wheel bolts to mount the collapsible spare wheel could damage the brake system.
WARNING
Make sure to use the original length wheel bolts when remounting the original wheel after it has been repaired.
- Clean the wheel and wheel hub contact surfaces.
To prevent damage to the paintwork, hold the wheel securely against the wheel hub while screwing in the first wheel bolt.
- Place the emergency spare wheel on the wheel hub and push it on.
- Tighten the wheel bolts until they are finger-tight.
- Inflate the collapsible spare wheel ().
Removing a wheel
Unscrew the wheel bolts. Do not place wheel bolts in sand or on a dirty surface. The bolt and wheel hub threads could otherwise be damaged when you screw them in. Remove the wheel. ...Inflating the collapsible spare wheel
WARNING Inflate the collapsible spare wheel only after the wheel is properly attached. Inflate the collapsible spare wheel using the tire inflation compressor before lowering the vehicle. ...See also:
Cleaning the Display
Notice: Using abrasive cleaners when cleaning glass surfaces could scratch the
glass. Use only a soft cloth and do not spray cleaner directly on the system as
it could affect the mechanical parts. ...
Reprogramming a single HomeLink® button
1. Press and hold the HomeLink® button
you wish to reprogram. DO NOT release
the button until step 4 has been completed.
2. When the HomeLink® indicator light
begins to flash slowly (after ap ...
Unfastening the seatbelt
Unfastening the seatbelt
Push the release button of the center
seatbelt buckle (on the left-hand side) to
unfasten the seatbelt.
NOTE
When the seatback is folded down for
greater cargo are ...