Jeep Liberty: Instrument Panel Dimmer
Rotate the center portion of the lever to the extreme bottom position to fully dim the instrument panel lights and prevent the interior lights from illuminating when a door is opened.
Rotate the center portion of the lever up to increase the brightness of the instrument panel lights when the parking lights or headlights are on.
Rotate the center portion of the lever upward to the next detent position to brighten the odometer and radio when the parking lights or headlights are on.
Rotate the center portion of the lever upward to the last detent to turn on the interior lighting.
Dimmer Control
Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...Map/Reading Lights
These lights are mounted between the sun visors on the overhead console and above the rear doors by the grab handles. Each light is turned on by pressing the lens. Press the lens a second time to ...See also:
Operation
Controls and display
1 Resume previous settings, increase speed (each additional press increases
speed by 1 mph (approximately 2 km/h).
2 Standby mode on/off
3 Set time interval
4 Put in activ ...
Important safety notes
When loading the vehicle, make sure that you do not stack the load in the cargo
compartment higher than the lower edge of the side windows. Do not place heavy objects
on top of the cargo compar ...
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the
“ON” position, the low tire pressure warning
light will illuminate for approximately 2
seconds to check that the tire pressure
monitoring syst ...