Jeep Liberty: Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released.
NOTE: If the multifunction lever is held in the flash-topass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before activating the flash-to-pass function again.
High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...Instrument Panel Dimmer
Rotate the center portion of the lever to the extreme bottom position to fully dim the instrument panel lights and prevent the interior lights from illuminating when a door is opened. Rotate th ...See also:
Switching the rear window wiper on/ off
Combination switch
Switch
To wipe with washer fluid
To switch on intermittent wiping
To switch off intermittent wiping
To wipe with washer fluid
Turn the SmartKey to position ...
Front passenger air bag and status light
Front passenger air bag status light
The front passenger air bag is designed
to automatically turn OFF under some
conditions. Read this section carefully
to learn how it operates. Proper ...
Battery
- Keep the battery surface clean and dry.
Clean the battery with a solution of baking
soda and water.
- Make certain the terminal connections are
clean and securely tightened.
- If the vehicle ...