Volvo XC60: High/low beam headlights - High/low beam headlights - Lighting - Your driving environment - Volvo XC60 Owner's ManualVolvo XC60: High/low beam headlights

Continuous high beams

1. Set the ignition to mode II.

2. With the light switch in position 0 or the, pull the turn signal lever toward the steering wheel to position 2 to toggle between high and low beams (this also applies on models equipped with the optional Active Bending Lights).

> The symbol instrument panel to indicate that the illuminates in the instrument panel to indicate that the high beams are on.

    High beam flash
    Move the lever toward the steering wheel to position 1. The high beams come on until the lever is released. ...

    Low beams
    When the engine is started, the low beams are activated automatically (daytime running lights) if the headlight control is in position 0 or . Daytime running lights can be deactivated in the ...

    See also:

    Seat Belt Lock Out
    The center rear seat belt system has a lock out feature that will not allow you to extract the center webbing unless the rear seat upper latch is engaged. ...

    Climate control air filter (in front of blower unit)
    (If installed) The climate control air filter is located in front of the blower unit behind the glove box. It operates to decrease the amount of pollutants entering the car. CAUTION: o Rep ...

    Intermittent wiping
    With the lever in this position, you can set the wiper interval by twisting the thumb wheel upward to increase wiper speed or downward to decrease the speed. ...