Subaru Forester: Headlight flasher - Light control switch - Keys and doors - Subaru Forester Owner's ManualSubaru Forester: Headlight flasher

Headlight flasher
Headlight flasher

To flash the headlights, pull the lever toward you and then release it. The high beam will remain on for as long as you hold the lever. The headlight flasher works even though the light switch is in the “OFF” position.

When the headlights are on high beam, the high beam indicator light “the” on the combination meter also illuminates.

Do not hold the lever in the flashing position for more than just a few seconds.

    High/low beam change (dimmer)
    High/low beam change (dimmer) To change from low beam to high beam, push the turn signal lever forward. When the headlights are on high beam, the high beam indicator light “” on the c ...

    Daytime running light system (if equipped)
    The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the “” position when it is ...

    See also:

    Reprogramming a single HomeLink® button
    1. Press and hold the HomeLink® button you wish to reprogram. DO NOT release the button until step 4 has been completed. 2. When the HomeLink® indicator light begins to flash slowly (after ap ...

    Paths
    The current menu level is displayed at the upper right of the center console display. Menu paths are displayed as follows, for example: Settings Car settings Lock settings Doors un ...

    Starter Switch Check
    WARNING When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. 1. Before starting this check, be sure there is enough room aroun ...