Jeep Liberty: Elapsed Time
Shows the total elapsed time of travel since the last reset.
Elapsed time will increment when the ignition switch is in the RUN or START position.
Elapsed time is displayed as follows:
hours:minutes:seconds
Elapsed time can be reset by pressing and holding the SELECT button (as prompted in the EVIC display). Upon reset all digits will change to zeros and time will start incrementing again if the ignition switch is in RUN or START.
Tire Psi
Press and release the MENU button until Tire PSI is displayed. Tire pressure information is displayed as follows: • If tire pressure is OK for all tires, TIRE and a vehicle graphic are display ...EVIC Units Selection (Units In Display)
Displays the units used for the Outside Temperature, Average Fuel Economy, Distance to Empty and Tire Pressure features. Press and release the SELECT button to toggle units between U.S. and METR ...See also:
Road warning
Hazard warning flasher The hazard warning flasher serves as a warning to other
drivers to exercise extreme caution when approaching, overtaking, or passing your
vehicle. It should be used whenev ...
Resetting triggered NECK-PRO head restraints
WARNING
For safety reasons, have the NECK-PRO head restraints checked at an authorized
Mercedes-Benz Center after a rear-end collision.
WARNING
When pushing back the NECK-PRO head restr ...
Brake Fluid
The brake master cylinder reservoir is filled with DOT 3 brake fluid as indicated
on the reservoir cap. See Engine Compartment Overview on page 10‑6 for the location
of the reservoir.
The ...