Range Rover Evoque: Driver override options
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Terrain response / Driver override options
Although Dynamic Stability Control is automatically engaged when a special program is selected, it can be turned off if required. See 91, DISABLING DSC.
Hill Descent Control (HDC) will be automatically engaged for some terrain response programs. If required it can be deselected or engaged independently of Terrain response. See 96, HILL DESCENT CONTROL (HDC) CONTROLS.
The HDC status will be displayed on the message centre whether it is engaged, or disengaged, by the system or by the driver.
READ NEXT:
System difficulties
Use of an incorrect program
will impair
the vehicle's response to the terrain and
can reduce the life of the suspension
and drive systems.
If the system becomes partially inoperable for
any re
Terrain response messages
Messages relating to the Terrain response
system are displayed in the message centre.
See 56, INSTRUMENT PANEL.
Most of the messages that appear will be for
information only and require no driver
SEE MORE:
Rear Door
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Hill descent control (HDC) controls
Hill descent control (HDC) controls
1. Press to switch HDC on and off.
2. Press to increase the set speed.
3. Press to decrease the set speed.
Manual transmission: HDC can be used in 1st,
2nd or reverse gears.
Automatic transmission: HDC can be used in
D, R and CommandShift 1, 2 or 3.
Note
© 2011-2024 Copyright www.rrevoque.org
