Range Rover Evoque: Terrain response messages

Messages relating to the Terrain response system are displayed in the message centre.

See 56, INSTRUMENT PANEL.

Most of the messages that appear will be for information only and require no driver intervention.

READ NEXT:

 Hill descent control

 Hill descent control (HDC) controls

Hill descent control (HDC) controls 1. Press to switch HDC on and off. 2. Press to increase the set speed. 3. Press to decrease the set speed. Manual transmission: HDC can be used in 1st, 2nd o

 Hdc operation

With HDC engaged, standard descent speed will not exceed 20km/h (12.4mph). While the green warning lamp is continuously illuminated, HDC target speed can be modified using the cruise control steer

SEE MORE:

 Crankshaft Position (CKP) Sensor

Special Tool(s) 303-1390A CKP Sensor Alignment Tool JLR-303-1595 Alignment Tool, Crankshaft Damper Removal NOTE: Removal steps in this procedure may contain installation details. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: Wheel and Tire

 Diesel engined vehicles

Do not use RME (bio-diesel) except in the case of those proprietary diesel fuels which contain a mix of up to 7%. Land Rover vehicles can accept no responsibility for damage caused by using RME in concentrations greater than 7%. Use only high quality diesel fuel according to EN590 or equi

© 2011-2024 Copyright www.rrevoque.org