Jeep Liberty: Parksense Rear Park Assist — If Equipped
The ParkSense Rear Park Assist system provides visual and audible indications of the distance between the rear fascia and a detected obstacle when backing up, e.g.
during a parking maneuver. Refer to ParkSense System Usage Precautions for limitations of this system and recommendations.
ParkSense will retain the last system state (enabled or disabled) from the last ignition cycle when the ignition is changed to the ON/RUN position.
ParkSense can be active only when the shift lever is in REVERSE. If ParkSense is enabled at this shift lever position, the system will remain active until the vehicle speed is increased to approximately 11 mph (18 km/h) or above. The system will become active again if the vehicle speed is decreased to speeds less than approximately 10 mph (16 km/h).
- Parksense Sensors
- Parksense Warning Display
- Parksense Display
- Enabling And Disabling Parksense
- Service The Parksense Rear Park Assist System
- Cleaning The Parksense System
- Parksense System Usage Precautions
To Accelerate For Passing
Press the accelerator as you would normally. When the
pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control On Hills
The transmission may downshift on hills t ...
Parksense Sensors
The four ParkSense sensors, located in the rear fascia/
bumper, monitor the area behind the vehicle that is
within the sensors’ field of view. The sensors can detect
obstacles from approximate ...
See also:
Adjusting the seats
Vehicles without Memory function: the seats can be adjusted within three minutes
of a front door being opened.
The time period starts over again if, within these three minutes, you:
open or ...
Operating tips (for automatic air conditioner)
When the engine coolant temperature and
outside air temperature are low, the air flow
from the foot outlets may not operate for a
maximum of 150 seconds. However, this is not a
malfunction. Af ...
To turn off fuel consumption indicator display
The fuel consumption indicator display
can be turned off.
To turn off this display, turn the ignition
switch to the “LOCK” position and press
the “+” button adjacent to the information ...
