Subaru Forester: To turn off fuel consumption indicator display - Information display - Keys and doors - Subaru Forester Owner's ManualSubaru Forester: To turn off fuel consumption indicator display

The fuel consumption indicator display can be turned off.

To turn off this display, turn the ignition switch to the “LOCK” position and press the “+” button adjacent to the information display for approximately 5 seconds.

Then, the information display and the clock display will blink for 3 seconds to notify you that the fuel consumption display has been turned off.

To restore the indicator, once again press the “+” button for approximately 5 seconds.

NOTE
- The initial display setting of the fuel consumption indicator of your vehicle has been set to operational at the time of shipment from the factory.

- The average fuel consumption is calculated even while the indicator is not displayed.

- Even if you turn off the fuel consumption indicator, the fuel consumption indicator will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.

    Average fuel consumption
    Average fuel consumption 1) U.S.-spec. models 2) Except U.S.-spec. models This indication shows the average rate of fuel consumption since the trip meter was last reset. When either of th ...

    Light control switch
    The light control switch only operates when the ignition key is inserted into the ignition switch. Regardless of the position of the light control switch, the illuminated lights are turned of ...

    See also:

    Two-Wheel Drive Models
    The manufacturer recommends towing your vehicle with all four wheels OFF the ground using a flatbed. If flatbed equipment is not available, and the transmission is operable, the vehicle may be to ...

    adaptive front lighting system (AFS)
    With the headlamps on, AFS will adjust the beams when cornering to provide improved illumination in the direction of travel. When a direction indicator is activated at speeds up to 40km/h (25mph), ...

    How to preset channels
    1. Press the “SAT” button to select SAT1, SAT2 or SAT3 reception. 2. Select the desired channel. 3. Press one of the preset buttons (from to ) for more than 1.5 seconds to store the cha ...