Jeep Liberty: High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam.
Turn Signals
Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. Turn Signal Control NOTE: ...Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...See also:
Light control and wiper control levers/switches
1) Windshield wiper
2) Mist
3) Windshield washer
4) Rear window wiper and washer switch
5) Wiper intermittent time control switch
6) Wiper control lever
7) Light control switch
8) Fo ...
Tire Inflation Pressures
The proper cold tire inflation pressure is listed on the
driver’s side “B” Pillar or rear edge of the driver’s side
door.
The pressure should be checked and adjusted, as well as
inspect ...
Blocking wheels
Place suitable blocks 1 at both the front and
back of the wheel diagonally opposite the flat
tire to prevent the vehicle from moving when it is
jacked up.
Be sure to block the wheel as th ...