Volvo XC60: Accessing the tire sealing system
The tire sealing system is stowed under the floor of the cargo area. To access it:
1. Lift the floor hatch in the cargo area.
2. Lift out the tire sealing system.
NOTE
• The tire sealing system is only intended
to seal holes on the tire’s tread area, not
the sidewall.
• Tires with large holes or tears cannot be
repaired with the tire sealing system.
• After use, stow the tire sealing system
properly to help prevent rattling.
WARNING
• After using the tire sealing system, the
vehicle should not be driven farther than
approximately 120 miles (200 km).
• Have the tire inspected by a trained and
qualified Volvo service technician as
soon as possible to determine if it can
be permanently repaired or must be
replaced.
• The vehicle should not be driven faster
than 50 mph (80 km/h) while using a tire
that has been temporarily repaired with
the tire sealing system.
• After using the tire sealing system, drive
carefully and avoid abrupt steering
maneuvers and sudden stops.
Introduction
Certain models are equipped with a tire sealing
system* that enables you to temporarily seal a
hole in the tread surface and re-inflate a flat tire,
or to adjust a tire’s inflation pressure.
...
Tire sealing system–overview
1 Speed limit sticker
2 On/Off switch
3 Electrical wire
4 Bottle holder (orange cover)
5 Protective hose cover
6 Air release knob
7 Hose
8 Bottle with sealing compound
9 Air pressure gauge
...
See also:
Licence terms
These licence terms are governed by English
Law and are subject to the exclusive
jurisdiction of the English courts. ...
Key positions
LOCK (0)
Except for the Intelligent Key equipped
model:
The key can only be removed from the ignition
switch at this position.
For the Intelligent Key equipped model:
PUSH OFF -
The ignition ...
Heating and defrosting
Heating and defrosting
To direct warm air toward the floor and the
windshield:
1. Set the airflow control dial to the “”
position.
2. Set the temperature control dial to the
most com ...
