Jeep Liberty: Fluid Level Check
The fluid level should be to the bottom edge of the fill hole (1) when the vehicle is in a level position.
1 — Fill Plug
2 — Drain Plug
Transfer Case
...Adding Fluid
Fluid should be added only to fill hole until fluid begins to run out of the hole. ...See also:
Temperature controls
Rotate to set a temperature.
Note: The maximum possible temperature
differential between the driver and passenger
settings is 4°C (7°F). ...
Ignition Switch
The ignition switch has four
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III).
LOCK (0) - You can insert or
remove the key only in this position.
To turn the key, the shift lev ...
Bulb specification chart
Before attempting to replace
a bulb,
ensure that both the affected lamp and
the vehicle's ignition, are turned off. If
the circuit remains live, a short circuit
can occur which may damage the
...