Jeep Liberty: Adding Fluid - Transfer Case - Maintenance Procedures - Maintaining Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Adding Fluid

Fluid should be added only to fill hole until fluid begins to run out of the hole.

    Fluid Level Check
    The fluid level should be to the bottom edge of the fill hole (1) when the vehicle is in a level position. 1 — Fill Plug 2 — Drain Plug ...

    Draining Fluid
    First remove the fill plug (1), then the drain plug (2). Recommended tightening torque for the drain and fill plugs is 15–25 ft lbs (20–34 N·m). CAUTION! Do not over-tighten the plugs. You ...

    See also:

    Closing Sunroof — Express
    Press the switch forward and release it within one-half second and the sunroof will close automatically from any position. The sunroof will close fully and stop automatically. This is called “E ...

    Activating/deactivating warning signals
    The collision warning system’s visual signals are activated automatically when the engine is started if the collision warning system is switched on. The audible warning signal can be activate ...

    Example of the type of accident in which the SRS side airbag will most likely deploy.
    A severe side impact near the front seat activates the SRS side airbag and SRS curtain airbag. ...