Subaru Forester: Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off.
Do the following to deactivate the audible signal. You can also use the same steps to restore the function.
1. Sit in the driver’s seat and shut all doors and the rear gate.
2. Hold down the UNLOCK side of the power door locking switch.
3. While holding down the “UNLOCK” side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after step 2.
4. Open and close the driver’s door once within 10 seconds after step 3.
5. The turn signal lights flash 3 times to indicate completion of the setting.
You may have the above settings done by your SUBARU dealer. Contact your SUBARU dealer for details. For models with a genuine SUBARU navigation system, the settings can be changed using the navigation monitor. For details, refer to the Owner’s Manual Supplement for the navigation system.
Selecting turn signal lights operation
When the remote keyless entry system is used, the turn signal lights flash. However, the turn signal lights flashing operational non-operational setting can be changed. Models with genuine SUBA ...Replacing the battery
- Do not let dust, oil or water get on or in the transmitter when replacing the battery. - Be careful not to damage the printed circuit board in the transmitter when replacing the battery ...See also:
Rear window and outside rear view mirror defoggers
The rear window defogger is used to defog the rear window. The outside
rear view mirror defoggers* are used to remove frost, dew or
raindrops from the outside rear view mirrors.
Vehicles with manua ...
Hiding display messages
You can hide some display messages with a low priority.
Press the or
button on the steering wheel to
hide the display message. The display message is cleared.
Display messages with a hig ...
Adjusting the front seat shoulder belt anchor height
Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be
adjusted to the position best suited for the
driver/front passenger. Always adjust the
anchor he ...