Subaru Forester: Registering (pairing) device - Setting Bluetooth® audio - Bluetooth® audio (type C and D audio) - Audio - Subaru Forester Owner's ManualSubaru Forester: Registering (pairing) device

1. Select the “PAIR AUDIO” (type C audio)/“Pair Audio Player” (type D audio) menu. If a device is already registered, “MEMORY FULL” is displayed and the mode changes to the Bluetooth® audio setting mode.

2. After the passkey is shown on the display, input the passkey into the cell phone. If you input the correct passkey, “PAIRED” is displayed and the registering procedure is finished. If you input an incorrect passkey, “FAILED” is displayed, the registering procedure was not successful and the mode changes to the Bluetooth® audio setting mode.

NOTE
After the ignition switch is turned to the “LOCK” position, the registered device is not automatically connected to the system even if the ignition switch is turned to the “Acc” or “ON” position.

    Setting Bluetooth® audio
    1. Select “BT-A SETUP” by pressing the “MENU” button (type C audio)/Select “BT Audio Setup” by operating the “TUNE/ TRACK/CH” dial (type D audio). 2. Perform the following proce ...

    Selecting device
    1. Select the “SELECT AUDIO” (type C audio)/“Select Audio Player” (type D audio) menu. If no devices are registered, “EMPTY” is displayed and the mode changes to the Bluetooth® au ...

    See also:

    Spare Tire Removal
    Fit the jack handle extension over the drive nut located in the rear cargo area inside the vehicle. Use the lug wrench to rotate the nut counterclockwise until the spare is on the ground with en ...

    Towing This Vehicle Behind Another Vehicle
    ...

    “PASS AIR BAG OFF” Indicator
    “PASS AIR BAG OFF” Indicator The “PASS AIR BAG OFF” indicator is located on the center of the instrument panel. When the ignition switch is turned to the “ON” position, this indicato ...