Jeep Liberty: Spare Tire Removal
Fit the jack handle extension over the drive nut located in the rear cargo area inside the vehicle. Use the lug wrench to rotate the nut counterclockwise until the spare is on the ground with enough slack in the cable to allow you to pull the tire out from under the vehicle.
Lowering/Raising Spare Tire
CAUTION!
The winch mechanism is designed for use with the
jack extension tube only. Use of an air wrench or
other power tools is not recommended and they can
damage the winch.
When the spare is clear, tilt the retainer at the end of the cable, and pull it through the center of the wheel.
NOTE: Refer to “Compact Spare Tire” under “Tires- General Information” in “Starting And Operating” for information about the compact spare tire, its use, and operation.
Spare Tire Stowage
The spare tire is stowed underneath the rear of the vehicle and is held in place by a cable winch mechanism. ...Preparations For Jacking
1. Park the vehicle on a firm level surface as far from the edge of the roadway as possible. Avoid icy or slippery areas. WARNING! Do not attempt to change a tire on the side of the vehicle c ...See also:
After the operation
1. Lower the vehicle carefully to the ground.
2. Dispose of waste oil and filter properly.
- Prolonged and repeated contact
with used engine oil may cause skin
cancer.
- Try to avoid direct ...
Programming trouble-diagnosis
If HomeLink® does not quickly learn the handheld
transmitter information:
- replace the hand-held transmitter batteries
with new batteries.
- position the hand-held transmitter with its
batt ...
Using the repair kit
Avoid skin contact with the
sealant
which contains natural rubber latex.
Do not unscrew the sealant bottle from
the receiver until it is empty, as
sealant will leak out.
If the tyre inflation ...