Subaru Forester: Reclining the seatback (if equipped)
To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place objects such as cushions between the passenger and the seatback. If you do so, the risk of sliding under the lap belt and of the lap belt sliding up over the abdomen will increase, and both can result in serious internal injury or death.
If the vehicle is equipped with a cargo area cover, observe the following precautions.
- Be careful not to pinch your hand between the headrest and the cargo area cover when you recline the rear seat.
- Move the front cover of the cargo area cover backward so that the cover is not damaged by the reclined seatback. Refer to “Cargo area cover (dealer option)”.
Push the switch and adjust the seatback to the desired position.
Then release the switch and make sure the seatback is securely locked into place.
Rear center seating position
The head restraint is not intended to
be used at the lowest position.
Before sitting on the seat, raise the
head restraint to an appropriate
position depending on your sitting
height.
...
Folding down the rear seatback
- When you fold down the seatback,
confirm that there are no
passengers or objects on the
rear seat. Not doing so creates
a risk of injury or property damage
if the seatback suddenly
f ...
See also:
Delete/Erase “All” Uconnect™ Phonebook Entries
• Press the button to begin.
• After the “Ready” prompt and the following beep, say
“Phonebook Erase All”.
• The Uconnect™ Phone will ask you to verify that you
wish to delete a ...
Create a MyKey
To program MyKey on one of the keys programmed to the vehicle,
insert the key that you want to make a MyKey into the ignition. Turn
the ignition on. Use the message center buttons to do the followin ...
Full screen view controls
When full screen mode is selected, the seek
controls operate in the same manner as they do
in preview mode.
Display format: Use the relevant soft key to
select the 4:3, 16:9 or Zoom option.
Digit ...
