Subaru Forester: Rear center seating position
The head restraint is not intended to be used at the lowest position.
Before sitting on the seat, raise the head restraint to an appropriate position depending on your sitting height.
A) When not used (retracted position)
B) When used (click position)
1) Head restraint
2) Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks.
When the rear-center seating position is occupied, raise the head restraint to an appropriate position depending on your sitting height. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility.
Rear windows side seating position
Rear windows side seating position 1) Head restraint 2) Release button To remove: While pressing the release button, pull out the head restraint. To install: Install the head restraint into ...Reclining the seatback (if equipped)
To prevent the passenger from sliding under the seatbelt in the event of a collision, always put the seatback in the upright position while the vehicle is in motion. Also, do not place ...See also:
Power seat (driver’s seat – if equipped)
1) Seat position forward/backward control
switch
To adjust the seat forward or backward,
move the control switch forward or
backward. During forward/backward adjustment of the seat, you canno ...
Cleaning the interior
Some cleaning products
contain
substances that are harmful and can
cause health problems if used
incorrectly and may cause damage to
the vehicle interior. Ensure that you
read the manufacturer ...
Removing the cover
1. Press one of the end pieces of the cover
inward.
2. Pull the cover carefully upward and outward.
The other end will release automatically
from its retaining bracket. ...