Suzuki Grand Vitara: Parking Brake Lever
Parking Brake
Lever (1) To set (2) To release (3) To release
The parking brake lever is located between the seats. To set the parking brake, hold the brake pedal down and pull the parking brake lever all the way up. To release the parking brake, hold the brake pedal down, pull up slightly on the parking brake lever, push the button on the end of the lever with your thumb and lower the lever to its original position. For automatic transmission vehicles, always set the parking brake before moving the gearshift lever to the “P” (Park) position. If you park on an incline and shift into “P” before you set the parking brake, the weight of the vehicle may make it difficult to shift out of “P” when you are ready to drive the vehicle. When preparing to drive the vehicle, move the gearshift lever out of the “P” position before releasing the parking brake.
WARNING:
• Never drive your vehicle with the parking brake set: rear brake effectiveness
can be reduced from overheating, brake life may be shortened or permanent brake
damage may result.
• If the parking brake does not hold the vehicle securely or does not fully release,
have your vehicle inspected immediately by an authorized SUZUKI dealer.
WARNING: Always set the parking brake fully before leaving your vehicle or it may roll, causing injury or damage. When parking, make sure the gearshift lever for manual transmission vehicles is in 1st gear or “R” (Reverse) and the gearshift lever for automatic transmission vehicles is in “P” (Park). Never leave the transfer lever in “N” (Neutral) when you are parked. Remember, even though the transmission is in gear or in Park, you must set the parking brake fully.
Pedals
Manual transmission Automatic transmission Clutch Pedal (1) (For manual transmission). The clutch pedal is used to disengage the drive to the wheels when starting the engine, stopping or shifti ...See also:
Electronic Vehicle Information Center (EVIC) — If Equipped
The Electronic Vehicle Information Center (EVIC) features
a driver-interactive display that is located in the
instrument cluster.
Electronic Vehicle Information Center (EVIC)
This system conve ...
Safety notes
WARNING
Work improperly carried out on electronic components and associated software
could cause them to cease functioning. Because the vehicle's electronic components
are interconnected ...
Switching BLIS on and off
BLIS is automatically activated when the ignition
is switched on. The indicator lights will
provide confirmation by flashing 3 times.
• The system can be switched off by pressing
the BLIS b ...