Volvo XC60: Operation
Controls and display
1 Resume previous settings, increase speed (each additional press increases
speed by 1 mph (approximately 2 km/h).
2 Standby mode on/off
3 Set time interval
4 Put in active mode and set a speed
5 Set speed (parentheses indicate standby mode)
6 Time interval while it is being set
7 Time interval after it has been set
- Putting ACC in standby mode
- Setting a speed
- Changing the set speed
- Setting a time interval
- Standby mode (temporary deactivation)
- Standby mode due to action by the driver
- Automatic standby mode
- Queue Assist
- Turning ACC off completely
Steep inclines and/or heavy loads
ACC is primarily intended for use on fairly level
roads. The system may have difficulty maintaining
the correct distance to a vehicle ahead
on steep inclines, if the vehicle is carrying a
heav ...
Putting ACC in standby mode
Before ACC can be used to regulate speed
and/or the distance to a vehicle ahead, it must
first be put in standby mode.
To do so:
Press .
The symbol appears in the display
and
parentheses ( ...
See also:
Trailer direction indicators (green)
Trailer direction indicators (green)
Illuminates briefly when the
ignition is switched on and
extinguishes when the engine is
started.
If a trailer is attached, the warning lamp will
flash in ...
Driving tips
Do not drive with your foot resting on the
clutch pedal and do not use the clutch to
hold your vehicle at a standstill on an
upgrade. Either of those actions may
cause clutch damage.
Do not d ...
Introduction
You can establish a BluetoothВ® connection to the audio system or to COMAND (see
the separate operating instructions).
WARNING
A driver's attention to the road must always be his/her prim ...
