Volvo XC60: High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or , pull the turn signal lever toward the steering wheel to position 2 to toggle between high and low beams (this also applies on models equipped with the optional Active Bending Lights).
> The symbol illuminates in the instrument panel to indicate that the high beams are on.
High beam flash
Move the lever toward the steering wheel to position 1. The high beams come on until the lever is released. ...Low beams
When the engine is started, the low beams are activated automatically (daytime running lights) if the headlight control is in position 0 or . Daytime running lights can be deactivated in the ...See also:
Setting the Clock
On models without navigation system
To set the time, press the CLOCK
button until you hear a beep. The
displayed time begins to blink.
Change the hours by pressing the H
(hour) button until th ...
Edit Uconnectâ„¢ Phonebook Entries
NOTE:
• Editing names in the phonebook is recommended
when the vehicle is not in motion.
• Automatic downloaded phonebook entries cannot be
deleted or edited.
• Press the button to begi ...
Important safety notes
WARNING
It is dangerous to shift the automatic transmission out of parking position P
or neutral position N if the engine speed is higher than idle speed. If your foot
is not firmly on the b ...