Subaru Forester: High beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side).
2. Disconnect the electrical connector from the bulb.
3. Remove the bulb from the headlight assembly by turning it counterclockwise.
4. Replace the bulb with new one. At this time, use care not to touch the bulb surface.
5. To install the bulb to the headlight assembly, turn it clockwise until it clicks.
6. Reconnect the electrical connector.
7. Install the air intake duct with clips (right-hand side).
Low beam light bulbs
Right-hand side
1. Use a screwdriver to undo the clips on
the air intake duct, then remove the air
intake duct (right-hand side).
Left-hand side
2. Use a screwdriver to remove the
secured ...
Position light
1. Turn the bulb socket counterclockwise
and pull out the socket.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Install the bulb socket by turning it
clockwise. ...
See also:
Federal Communications Commission (FCC) Rules and with Industry Canada Standards
See Radio Frequency Statement on page 13‑21 for information regarding Part 15
of the Federal Communications Commission (FCC) Rules and with Industry Canada Standards
RSS-GEN/210/220/310. ...
Foreword
Your SUZUKI multipurpose vehicle is designed and built to be capable of performing
both on pavement and off road. You should therefore remember that your vehicle is
distinctly different from ordin ...
Roof molding and crossbar (if equipped)
- For cargo carrying purposes, the
roof molding must never be used
alone to carry cargo. Otherwise,
damage to the roof or paint or a
dangerous road hazard due to
loss of cargo could ...
