Range Rover Evoque: Drive selector

P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.

If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.

If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.

READ NEXT:

 Drive selector fails to elevate

If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal. If the selector still fails to elevate, even if there is no obstructio

 Transmission fault

In the event that the transmission develops a fault, a warning message may be displayed in the message centre and only limited gears may become available. You should seek qualified assistance imme

 Manual transmission

Manual transmission Selection of reverse gear is prevented when the vehicle is travelling in excess of 24km/h (15mph). Never attempt to engage reverse gear while the vehicle is in forward mo

SEE MORE:

 Rear Wheelhouse Front Extension

Removal NOTE: The rear wheelhouse front extension is taken from the rear wheelhouse outer and is manufactured from mild steel. 1. The rear wheelhouse outer is replaced in conjunction with: Rear bumper cover Quarter panel Quarter glass Front inner quarter panel 2. For additional information r

 Front Seat Height Adjustment Motor

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Disconnect the battery ground cable. Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications). 2. WARNING: To avoid accidental deployment, the restraints control module backup power

© 2011-2024 Copyright www.rrevoque.org