Range Rover Evoque: Drive selector fails to elevate
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Drive selector fails to elevate
If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal.
If the selector still fails to elevate, even if there is no obstruction, a fault in the system is indicated. The selector can still be used in the lowered position. Ensure that P is selected before engine switch off. Have the fault rectified at the earliest opportunity.
READ NEXT:
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
Gear shift indicator
The gear shift indicator
illuminates
briefly at the recommended gear
change point (upshift).
The shift indicator will not illuminate while
Cruise control is active and is not being
overridden
SEE MORE:
Coolant antifreeze
Antifreeze is poisonous and
can be
fatal if swallowed - keep containers
sealed and out of the reach of
children. If accidental consumption is
suspected, seek medical attention
immediately.
If the fluid comes into contact with the
skin or eyes, rinse immediately with
plenty of water.
The
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control arm
Subframe
Overview
The front suspension features long travel McPherson struts to optimize on a
© 2011-2024 Copyright www.rrevoque.org
