Nissan Rogue: Changing wheels and tires
Tire rotation
NISSAN recommends rotating the tires every 7,500 miles (12,000 km). (See “Flat tire” in the “6. In case of emergency” section for tire replacing procedures.)
As soon as possible, tighten the wheel nuts to the specified torque with a torque wrench.
Wheel nut tightening torque:
80 ft-lb (108 N·m)
The wheel nuts must be kept tightened
to the specification at all times.
It is recommended that wheel nuts be tightened to the specification at each tire rotation interval.
- After rotating the tires, check and adjust the tire pressure.
- Retighten the wheel nuts when the vehicle has been driven for 600 miles (1,000 km) (also in cases of a flat tire, etc.).
- Do not include the spare tire or any other small size spare tire in the tire rotation.
- For additional information regarding tires, refer to “Important Tire Safety Information” (US) or “Tire Safety Information” (Canada) in the Warranty Information Booklet.
1. Wear indicator
2. Wear indicator location mark
Tire chains
NISSAN recommends using the following
tire cables made by Peerless Chain
Company for this vehicle due to limited
tire clearance. Call 800-533-8056 to
order tire chains for your vehicle.
- ...
Tire wear and damage
- Tires should be periodically inspected
for wear, cracking, bulging
or objects caught in the
tread. If excessive wear, cracks,
bulging or deep cuts are found,
the tire(s) should be repl ...
See also:
Auxiliary Devices
For vehicles equipped with the MyLink or IntelliLink infotainment system, see
the separate MyLink/ IntelliLink Features and Functions Guide for more information.
This vehicle has an auxiliary input ...
Important safety notes
WARNING
Make sure the tailgate is closed when the engine is running and while driving.
Among other dangers, deadly carbon monoxide (CO) gases may enter vehicle interior
resulting in unconsci ...
Adjusting the set speed
After a speed has been set, it can be increased
or decreased by using the or
buttons.
1. Press and hold down or
until the
vehicle reaches the desired speed.
> This will become the set ...
