Jeep Liberty: Front Fog Lamp
1. Open the hood.
2. Reach behind the headlamp housing to access the bulb.
3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing.
4. Pull the bulb out of the socket and insert the replacement bulb.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.
5. Install the bulb and socket assembly into the into the fog lamp housing, and rotate the connector clockwise to lock it in place.
6. Close the hood.
Front Turn Signal And Front Side Marker Lamp
1. Turn the steering wheel all the way to the right to access the left front turn signal or side marker. Turn the steering wheel all the way to the left to access the right front turn signal or ...Rear Tail/Stop, Turn Signal, And Back-Up Lamp
1. Open the liftgate. 2. Remove the screws that fasten the taillamp housing to the vehicle. 3. Pull the taillamp housing straight back to separate it from the vehicle. 4. Disconnect the elect ...See also:
Maintenance product specifications and capacities
1Add the coolant type originally equipped in your vehicle.
2Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need
only meet the
requirements of Ford specification ...
Bi-level heating
Bi-level heating
This setting allows you to direct air of
different temperatures from the instrument
panel and foot outlets. The air from the
foot outlets is slightly warmer than from
the ...
Seat belt pretensioners
All seat belts are equipped with pretensioners
that reduce slack in the belts. These pretensioners
are triggered in situations where the
front or side impact airbags deploy, and in certain
imp ...