Jeep Liberty: Rear Tail/Stop, Turn Signal, And Back-Up Lamp
1. Open the liftgate.
2. Remove the screws that fasten the taillamp housing to the vehicle.
3. Pull the taillamp housing straight back to separate it from the vehicle.
4. Disconnect the electrical connector.
5. Remove the two screws that fasten the back plate to the taillamp housing.
6. Separate the back plate from the taillamp housing.
7. Pull the appropriate bulb(s) out of the back plate and insert the replacement bulb(s).
8. Install the back plate and screws into the taillamp housing.
9. Connect the electrical connector.
10. Install the taillamp housing and screws.
11. Close the liftgate.
Front Fog Lamp
1. Open the hood. 2. Reach behind the headlamp housing to access the bulb. 3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing. 4. ...Fluid Capacities
...See also:
Vehicle Dynamic Control (VDC) OFF switch
Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the Vehicle
Dynamic Control (VDC) system on for most
driving conditions.
If the vehicle is stuck in mud or snow, the ...
Closing
WARNING
Monitor the closing procedure carefully to make sure no one is in danger of being
injured. To prevent possible personal injury, always keep hands and fingers away
from the cargo comp ...
Phone Call Features
The following features can be accessed through the
Uconnectâ„¢ Phone if the feature(s) are available on your
mobile service plan. For example, if your mobile service
plan provides three-way call ...