Jeep Liberty: To Exit Remote Start Mode Without Driving The Vehicle - How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Exit Remote Start Mode Without Driving The Vehicle

Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle.

NOTE: To avoid unintentional shut downs, the system will disable the one-time press of the REMOTE START button for two seconds after receiving a valid Remote Start request.

    To Enter Remote Start Mode
    Press and release the REMOTE START button on the RKE transmitter twice within five seconds. The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will ...

    To Exit Remote Start Mode And Drive The Vehicle
    Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key in ...

    See also:

    Airbag srs (amber)
    Airbag srs (amber) Illuminates briefly when the ignition is switched on and extinguishes when the engine is started. If the lamp illuminates while driving, there is a fault with the airbag syst ...

    Seatbelt warning light and chime
    Your vehicle is equipped with a seatbelt warning device at the driver’s and front passenger’s seat, as required by current safety standards. With the ignition switch turned to the “ON ...

    Park position (P)
    Select the P position when starting or parking. Shiftlock When P has been selected, the transmission is mechanically blocked in this position. The brake pedal must be depressed and the ignition ...