Jeep Liberty: To Enter Remote Start Mode - How To Use Remote Start - Remote Starting System — If Equipped - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: To Enter Remote Start Mode

Press and release the REMOTE START button

Press and release the REMOTE START button on the RKE transmitter twice within five seconds.

The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.

NOTE:
• If your power door locks were unlocked, Remote Start will automatically lock the doors.

• If an engine fault is present or fuel level is low, the vehicle will start and then shut down in 10 seconds.

• For security, power window operation and sunroof or Sky Slider operation (if equipped) is disabled when the vehicle is in the Remote Start mode.

• The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle.

    Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
    The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood A ...

    To Exit Remote Start Mode Without Driving The Vehicle
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...

    See also:

    115 V power socket
    WARNING The 115V AC socket operates at high voltage. Use the 115V AC socket in the vehicle with the same caution and prudence that you exercise when using power outlets at home. Keep any flu ...

    Illumination brightness control
    Illumination brightness control The brightness of clock display, audio, air conditioner, information display and instrument panel illumination dims when the light switch is in the “” or ...

    To Change or Select Tracks/Files
    You can use the preset buttons while a card is playing to select or change files. Each preset button’s function is shown on the bottom of the screen. Icons on the screen can also be sel ...