GMC Terrain: Traction Control System (TCS)/StabiliTrak® Light - Warning Lights, Gauges, and Indicators - Instruments and Controls - GMC Terrain Owner's ManualGMC Terrain: Traction Control System (TCS)/StabiliTrak® Light

The StabiliTrak system or the Traction Control System (TCS) indicator/warning

The StabiliTrak system or the Traction Control System (TCS) indicator/warning light comes on briefly when the engine is started. If the light does not come on, have the vehicle serviced by your dealer. If the system is working normally, the indicator light turns off.

If the light is on and not flashing, the TCS, and potentially the StabiliTrak system have been disabled. A DIC message may display. Check the DIC messages to determine which feature(s) is no longer functioning and whether the vehicle requires service.

If the indicator/warning light is on and flashing, the TCS and/or the StabiliTrak system is actively working.

See StabiliTrak® System on page 9‑36 and Traction Control System (TCS) on page 9‑35 for more information.

    StabiliTrak® OFF Light
    This light comes on when the StabiliTrak system is turned off. If the Traction Control System (TCS) is off, wheel spin is not limited. If the StabiliTrak system is off, the system does not assis ...

    Tire Pressure Light
    For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS. When the Light Is O ...

    See also:

    Garage door opener programming in the U.S.A.
    NOTE When programming the HomeLink® Wireless Control System for a garage door opener, it is suggested that you park the vehicle outside the garage. 1. Unplug the motor of the garage door o ...

    Flash Lights With Lock
    The feature will cause the turn signal lights to flash when the doors are locked or unlocked with the RKE transmitter. This feature can be turned on or turned off. To change the current setting, ...

    Replacing high-mount brake lamp bulbs
    1. Remove the two screws and move the lamp assembly away from the liftgate. 2. Remove the bulb holder from the lamp assembly by pressing the snaps. 3. Pull the bulb straight out of the sock ...