Ford Escape: Replacing high-mount brake lamp bulbs - Replacing headlamp bulbs - Bulb Replacement - Lights - Ford Escape Owner's ManualFord Escape: Replacing high-mount brake lamp bulbs

1. Remove the two screws and move the lamp assembly away from the liftgate.

2. Remove the bulb holder from the

2. Remove the bulb holder from the lamp assembly by pressing the snaps.

3. Pull the bulb straight out of the

3. Pull the bulb straight out of the socket and push in the new bulb.

Install the new bulbs in reverse order.

Replacing license plate lamp bulbs

    Replacing tail/stop/turn/backup lamp bulbs
    The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Make sure the ...

    Replacing license plate lamp bulbs
    1. Make sure the headlamp switch is in the off position. 2. Press the lever and carefully pry the license plate lamp assembly (located above the license plate) from the liftgate. 3. Rotate the b ...

    See also:

    Draining of coolant water
    If the vehicle is to be left outside without antifreeze, drain the cooling system, including the engine block. Refill before operating the vehicle. For details, see “Engine cooling system” in ...

    Starting a disabled vehicle using booster cables
    Rotating parts of the engine can cause serious injury. Take extreme care when working near rotating parts of the engine. Before attempting to start the disabled vehicle, make sure that the par ...

    GVWR and GAWR (Gross Vehicle Weight Rating and Gross Axle Weight Rating)
    The certification label attached to the driver’s side doorjamb shows GVWR (Gross Vehicle Weight Rating) and GAWR (Gross Axle Weight Rating). The GVW (Gross Vehicle Weight) must never ex ...