Jeep Liberty: To Accelerate For Passing
Press the accelerator as you would normally. When the pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control On Hills
The transmission may downshift on hills to maintain the vehicle set speed.
NOTE: The Electronic Speed Control system maintains speed up and down hills. A slight speed change on moderate hills is normal.
On steep hills, a greater speed loss or gain may occur so it may be preferable to drive without Electronic Speed Control.
WARNING!
Electronic Speed Control can be dangerous where the
system cannot maintain a constant speed. Your vehicle
could go too fast for the conditions, and you
could lose control and have an accident. Do not use
Electronic Speed Control in heavy traffic or on roads
that are winding, icy, snow-covered or slippery.
To Vary The Speed Setting
When the Electronic Speed Control is set, you can increase
speed by pushing the RES (+) button. If the button
is continually pressed, the set speed will continue to
increase until the button is ...
Parksense Rear Park Assist — If Equipped
The ParkSense Rear Park Assist system provides visual
and audible indications of the distance between the rear
fascia and a detected obstacle when backing up, e.g.
during a parking maneuver. Refe ...
See also:
Brake temperature
In extreme circumstances, the HDC system
may cause brake temperatures to exceed their
pre-set limits. An HDC warning will be
displayed in the message centre. HDC will then
fade out and become temp ...
Removing the vehicle battery
Special tools are required to refit the battery
after removal, therefore battery removal and
refit should be carried out only by qualified
personnel. Consult your Dealer/Authorised
Repairer. ...
Tire Inflation Pressures
The proper cold tire inflation pressure is listed on the
driver’s side “B” Pillar or rear edge of the driver’s side
door.
The pressure should be checked and adjusted, as well as
inspect ...
