Jeep Liberty: Parksense Rear Park Assist — If Equipped
The ParkSense Rear Park Assist system provides visual and audible indications of the distance between the rear fascia and a detected obstacle when backing up, e.g.
during a parking maneuver. Refer to ParkSense System Usage Precautions for limitations of this system and recommendations.
ParkSense will retain the last system state (enabled or disabled) from the last ignition cycle when the ignition is changed to the ON/RUN position.
ParkSense can be active only when the shift lever is in REVERSE. If ParkSense is enabled at this shift lever position, the system will remain active until the vehicle speed is increased to approximately 11 mph (18 km/h) or above. The system will become active again if the vehicle speed is decreased to speeds less than approximately 10 mph (16 km/h).
- Parksense Sensors
- Parksense Warning Display
- Parksense Display
- Enabling And Disabling Parksense
- Service The Parksense Rear Park Assist System
- Cleaning The Parksense System
- Parksense System Usage Precautions
To Accelerate For Passing
Press the accelerator as you would normally. When the
pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control On Hills
The transmission may downshift on hills t ...
Parksense Sensors
The four ParkSense sensors, located in the rear fascia/
bumper, monitor the area behind the vehicle that is
within the sensors’ field of view. The sensors can detect
obstacles from approximate ...
See also:
Two separate circuits
Your vehicle has two separate circuit
brake systems. Each circuit works diagonally
across the vehicle. If one circuit of
the brake system should fail, the other half
of the system still works. ...
Seat belt maintenance
- To clean the seat belt webbing, apply a
mild soap solution or any solution recommended
for cleaning upholstery or carpets.
Then wipe with a cloth and allow the seat
belts to dry in the shade. ...
Skidding
There are three types of skids that correspond to the vehicle's three control
systems:
○ Braking Skid — wheels are not rolling.
○ Steering or Cornering Skid — too much speed or ...
