Subaru Forester: Heater operation
NOTE
- Models with air conditioner system:
When the “” or “”
position is
selected, the air conditioner compressor
automatically operates regardless
of the position of the air conditioner
button to defog the windshield more
quickly. At the same time, the air inlet
selection is automatically switched to
the OFF position (outside air). However,
the air conditioner indicator light
does not illuminate at this time.
- When defrosting, defogging or heating, warm air is also emitted from the right and left air outlets. To stop warm airflow from these outlets, turn the corresponding thumb wheel down.
Air inlet selection button
Air inlet selection button ON position (Recirculation): Interior air is recirculated inside the vehicle. Push the air inlet selection button to the ON position. The indicator light will illu ...Defrosting or defogging the windshield
Defrosting or defogging the windshield To direct warm air to the windshield and front door windows: 1. Set the airflow control dial to the “” position. 2. Turn the temperature control ...See also:
Used Replacement Wheels
WARNING
Replacing a wheel with a used one is dangerous. How it has been used or how far
it has been driven may be unknown. It could fail suddenly and cause a crash. When
replacing wheels, use a n ...
How to Check Lubricant
To get an accurate reading, the vehicle should be on a level surface.
If the level is below the bottom of the fill plug hole, located on the transfer
case, the vehicle will need some lubricant ad ...
Commands
The Voice Command system understands two types of
commands. Universal commands are available at all
times. Local commands are available if the supported
radio mode is active. ...