Subaru Forester: Ventilation - Heater operation - Manual climate control system (if equipped) - Climate control - Subaru Forester Owner's ManualSubaru Forester: Ventilation

Ventilation
Ventilation

To force outside air through the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.

2. Set the airflow control dial to the “position.” position.

3. Set the temperature control dial all the way left.

4. Set the fan speed control dial to the desired speed.

When driving on a dusty road, set the air inlet selection button to the “ON” position.

Continued operation with the air

Continued operation with the air inlet selection button in the ON position may fog up the windows.

Switch to the OFF position as soon as the outside dusty condition clears.

    Bi-level heating
    Bi-level heating This setting allows you to direct air of different temperatures from the instrument panel and foot outlets. The air from the foot outlets is slightly warmer than from the ...

    See also:

    Draining Fluid
    First remove the fill plug (1), then the drain plug (2). Recommended tightening torque for the drain and fill plugs is 15–25 ft lbs (20–34 N·m). CAUTION! Do not over-tighten the plugs. You ...

    Raising the vehicle
    WARNING When jacking up the vehicle, only use the jack which has been specifically approved by Mercedes-Benz for your vehicle. The jack is designed exclusively for jacking up the vehicle at t ...

    Drive sensibly – save fuel
    Observe the following tips to save fuel: The tires should always be inflated to the recommended tire pressure. Remove unnecessary loads. Remove roof racks when they are not needed. Warm up t ...