Range Rover Evoque: Drive selector
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Drive selector
P should normally be selected before switching off the engine. If any other gear is selected at turn off, the selector will move to P before retracting into the centre console.
If the engine is switched off with N selected, the system will wait for 10 minutes before selecting P. This time delay allows the vehicle enough time to be conveyed through a car wash. Do not use for vehicle recovery purposes.
If your vehicles requires recovery by towing, the recovery must be undertaken by qualified personnel. See 216, RECOVERY.
READ NEXT:
Drive selector fails to elevate
If the drive selector is obstructed, remove the
obstruction and then start the engine. The
selector should elevate as normal.
If the selector still fails to elevate, even if there
is no obstructio
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
SEE MORE:
Automatic transmission
The rotary drive selector rotates in either
direction. At engine start up, the selector
elevates out of its parked position.
1. To select D (Drive) or R (Reverse) gear,
apply the foot brake then rotate the drive
selector. The related LED by the selector
will illuminate.
Note: If pressure is
Crankshaft Position (CKP)
Sensor
Special Tool(s)
303-1390A
CKP Sensor Alignment Tool
JLR-303-1595
Alignment Tool, Crankshaft Damper
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Wheel and Tire
© 2011-2024 Copyright www.rrevoque.org
