Range Rover Evoque: Drive selector fails to elevate
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Gearbox / Drive selector fails to elevate
If the drive selector is obstructed, remove the obstruction and then start the engine. The selector should elevate as normal.
If the selector still fails to elevate, even if there is no obstruction, a fault in the system is indicated. The selector can still be used in the lowered position. Ensure that P is selected before engine switch off. Have the fault rectified at the earliest opportunity.
READ NEXT:
Transmission fault
In the event that the transmission develops a
fault, a warning message may be displayed in
the message centre and only limited gears may
become available. You should seek qualified
assistance imme
Manual transmission
Manual transmission
Selection of reverse gear is
prevented
when the vehicle is travelling in excess
of 24km/h (15mph). Never attempt to
engage reverse gear while the vehicle is
in forward mo
Gear shift indicator
The gear shift indicator
illuminates
briefly at the recommended gear
change point (upshift).
The shift indicator will not illuminate while
Cruise control is active and is not being
overridden
SEE MORE:
Driver Seat Cushion Vehicles With: Sports Seats
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General In
Unlocking the vehicle
To prevent accidental
operation,
never leave the Smart Key in the
vehicle if children or animals are also
left in the vehicle.
Note: The operational range of the Smart Key
will vary considerably depending on
atmospheric conditions and interference from
other transmitting devices.
Note:
© 2011-2024 Copyright www.rrevoque.org
