Jeep Liberty: Security
It is advised to erase all channels before you sell or turn in your vehicle.
To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased.
The HomeLink Universal Transceiver is disabled when the Vehicle Security Alarm is active.
Using HomeLink
To operate, press and release the programmed
HomeLink button. Activation will now occur for the
programmed device (i.e., garage door opener, gate operator,
security system, entry door lock, home ...
Troubleshooting Tips
If you are having trouble programming HomeLink , here
are some of the most common solutions:
• Replace the battery in the original hand-held transmitter.
• Press the LEARN button on the Garage ...
See also:
All-Wheel Drive
Vehicles with this feature always send engine power to all four wheels. It is
fully automatic, and adjusts itself as needed for road conditions.
When using a compact spare tire on an AWD vehicle, t ...
Tire designations
Information on the sidewall
Federal law mandates that tire manufacturers
place standardized information on the sidewall
of all tires (see the illustration).
The following information is listed ...
Side impact air bags
WARNING
The pressure sensors for side impact air bag control are located in the doors.
Do not modify any components of the doors or door trim panels including, for example,
the addition of d ...
