Ford Escape: Replacing fog lamp bulbs (if equipped)
1. Make sure the fog lamp switch is
in the off position.
2. From underneath the vehicle,
carefully disconnect the electrical
connector from the bulb.
3. Remove the bulb from the lamp
assembly by pulling out the bulb
while squeezing the upper and lower
snap clips at the same time.
Install the new bulb in reverse order.
Replacing license plate lamp bulbs
1. Make sure the headlamp switch is in the off position. 2. Press the lever and carefully pry the license plate lamp assembly (located above the license plate) from the liftgate. 3. Rotate the b ...Driver Controls
...See also:
Important safety notes
WARNING
Make sure the cargo net is properly engaged at top and bottom position and the
tightening belts are securely fastened.
Never use a damaged cargo net. Always use cargo net when transpo ...
Important safety notes
For reasons of safety, Mercedes-Benz recommends that you drive with the lights
switched on even during the daytime. In some countries, operation of the headlamps
varies due to legal requirements a ...
Tire chains
Tire chains, if necessary, should be
installed on the front wheels. Be sure
that the chains are installed in accordance
with the manufacturer's instructions.
To minimize tire and chain wear, d ...